A: Yes, IF you do not need the strobe functionality of the light. To wire the TriAnchor to your existing Anchor and Tricolor circuit breakers, you will need to use all three wires from the light. Follow the wiring diagram below. Connect the black wire (formerly the shield wire on previous versions without a connector) to the negative or electrical ground of your boat’s electrical system. Connect the brown wire (formerly the black wire on previous versions without connector) to the Anchor circuit breaker. Finally, connect the blue wire (formerly the red wire on previous versions without the connector) to the Tricolor circuit breaker.
NOTE: The circuit breaker should not be rated for more than 5 Amps. The LED light draws less than 1 Amp. If the breaker is rated too high, there is a greater danger of fire or catastrophic damage to the light and wiring if there is a failure. OGM is not responsible for damage from incorrectly installed lights.
NOTE: The circuit breaker should not be rated for more than 5 Amps. The LED light draws less than 1 Amp. If the breaker is rated too high, there is a greater danger of fire or catastrophic damage to the light and wiring if there is a failure. OGM is not responsible for damage from incorrectly installed lights.
